Black & Decker FIRESTORM FS210LS Bedienerhandbuch PDF herunterladen (Seite 16)

RIP FENCE

1. Thread the M8x1.25 hex nut (A) Fig. 26,

approximately halfway on the stud of the handle (B).

2. Thread the handle (B) Fig. 26 into the tapped hole

against the cam (D).

3. Lower rip fence onto table as shown in Fig. 27,

making certain rear clamp hooks over back edge of

table.

4. The rip fence is usually operated on the right hand

side of the saw table. Lift lock handle (B), and position

fence on table. Push downward on handle (B), to lock

fence in place on saw table.

MITER GAGE

The miter gage is shipped completely assembled and is

supplied with a T-slot miter gage bar (A) Fig. 28, that is

inserted into either one of the two T-slotted miter gage

grooves located in the table top, as shown. The T-slot

miter gage prevents the miter gage from falling when it

is extended out beyond the front of the table when

cross-cutting extra wide workpieces.

Fig. 26

Fig. 27

Fig. 28

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 67 68

Keine Kommentare

Black & Decker FIRESTORM FS210LS Bedienerhandbuch Seite 16