Black & Decker FIRESTORM FS210LS Bedienerhandbuch PDF herunterladen (Seite 14)

7. Assemble splitter (H) Fig. 19, to splitter support

bracket (B) as shown using M6x1x20mm hex head

screw (L), 1/4 in. external tooth washer, and 1/4 in. flat

washer.

8. Fasten splitter (H) Fig. 20, to splitter support bracket

using 1/4 in. flat washer, 1/4 in. external tooth

lockwasher and M6 wing nut (M). NOTE: Before

tightening wing nut (M) make certain there is at least a

1/8 in. gap between the bottom edge of splitter (N) and

top surface of table (P) and that protrusion “pins” (K) Fig.

20, are inside the slot of splitter assembly (H).

9. Using a straight edge, check to see if the splitter (H)

Fig. 21, is aligned with the saw blade (R). If an

adjustment is necessary, the splitter (H) can be moved

left or right and rotated.

10. When you are certain the splitter is properly aligned

with the saw blade, tighten the two screws (C) Fig. 22,

that fasten the splitter support bracket to the splitter

bracket and tighten screw (G) that fastens the splitter

bracket to the pivot rod.

Fig. 19

Fig. 20

Fig. 21

Fig. 22

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 67 68

Keine Kommentare

Black & Decker FIRESTORM FS210LS Bedienerhandbuch Seite 14