Black & Decker DCM200C Installationsanleitung PDF herunterladen (Seite 12)

DCM 200 Installation

Page 12

2.2.2.

Sensor Installation

• Check that all fittings of the assembly have O-rings installed, and fittings are secure.

• Adjust flow switch shaft so the top of the ring at the bottom of the shaft is at the 12.5 gph mark, and

tighten the compression nut to keep the shaft from leaking and secure the flow switch shaft in place.

• When you are ready to open up the sample water valves, remove the protective caps from the pH and

ORP sensors, and clean both sensors with Isopropyl alcohol followed by a mild acid, using a soft

bristled toothbrush.

• Open the supply and return valves fully to evacuate all the air from the modular sensor housing.

• Once all air has been evacuated, reduce flow through the assembly to 10-12 GPH for optimum sensor

performance.

• Allow sensors to equilibrate while you complete the wiring of the controller.

ORP sensor

pH sensor

SGT sensor

Aquatic Sensor Placement in

DGMa Modular Sensor Housing

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 33 34

Keine Kommentare

Black & Decker DCM200C Installationsanleitung Seite 12