7
Charge only at ambient temperatures between 10 °C
and 40 °C.
Charge only using the charger provided with the
appliance/tool. Using the wrong charger could result in
an electric shock or overheating of the battery.
When disposing of batteries, follow the instructions
given in the section "Protecting the environment".
Do not damage/deform the battery pack either by
puncture or impact, as this may create a risk of injury
and fire.
Do not charge damaged batteries.
Under extreme conditions, battery leakage may occur.
When you notice liquid on the batteries, carefully wipe
the liquid off using a cloth. Avoid skin contact.
In case of skin or eye contact, follow the instructions
below.
Warning! The battery fluid may cause personal injury or
damage to property. In case of skin contact, immediately
rinse with water. If redness, pain or irritation occurs seek
medical attention. In case of eye contact, rinse immediately
wit
h clean water and seek medical attention.
Chargers
Your charger has been designed for a specific voltage.
Always check that the mains voltage corresponds to the
voltage on the rating plate.
Warning! Never attempt to replace the charger unit with a
regular mains plug.
Use your Black & Decker charger only to charge the
battery in the appliance/tool with which it was supplied.
Other batteries could burst, causing personal injury and
damage.
Never attempt to charge non-rechargeable batteries.
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
Do not open the charger.
Do not probe the charger.
The appliance/tool/battery must be placed in a well
ventilated area when charging.
Labels on the charger
The following symbols are found on your charger:
Features
1. Top jaw
2. Lower jaw
3. Chain gui
de bar
4. Oiling cover
5. Latch
6. Battery
7. On/off switch actuators
8. Chipping ejection point
9. Charger
Assembly
Warning! Before assembly, remove the battery (6) from the
tool.
Fitting and removing the battery (fig. A)
To fit the battery (6), line it up with the receptacle on the
tool. Slide the battery (6) into the receptacle and push
until the battery (6) snaps into place.
To remove the battery (6), push the release button (18)
while at t
he same time pulling the battery (6) out of the
receptacle.
Opening the handles (fig. B)
To open the handles, slide the latch (5) backwards and
pull the handles apart.
After use, close the handles and slide the latch (5)
forward to the lock position. The handles should be
locked during transportation and storage.
Chain tension adjustment (fig. C)
Warning! Before adjusting the chain tension or any other
adjustments, make sure that the tool is switched of
f and the
battery removed.
Warning! The chain guide bar and the saw chain may be hot
after use. Allow to cool before adjustment.
The product comes ready assembled. However we
recommend that you check the tension of the saw chain (14),
Your charging base is double insulated; therefore
no earth wire is required. Always check that the
power supply corresponds to the voltage on the
rating plate.
The charging base is intended for indoor use only.
Read the instruction manual before use.
The charger automatically shuts off if the ambient
temperature becomes too high. As soon as the
ambient temperature has cooled down, the charger
will resume operating.
Charge only at ambient temperatures between
10°C and 40°C.
130
o
C
(60 Seiten)
(16 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern