Black & Decker BDP2600 Bedienungsanleitung PDF herunterladen (Seite 14)

14- ENG

Engine

Consult the Engine Owners Manual for

the man u fac tur er's recommendations

for any and all maintenance.

Pump

NOTE: The pump was filled with oil at

the factory.

Change pump oil after the first 10

hours of operation and every 250 hours

thereafter.

To Check Oil

The oil level should

BB

CC

AA

come to the dot in

the middle of the

sight glass (AA).

How To Change

Pump Oil

1. Loosen pump

oil fill plug (BB).

2. Place a con-

tainer under the oil drain plug

(CC).

3. Remove pump oil drain plug.

4. After oil is drained, replace oil drain

plug. Tighten securely.

5. Remove pump oil plug and fill with

8.5 oz. (251 ml) of 30W non deter-

gent oil.

6. Replace pump oil plug and tighten

securely.

Nozzle Cleaning

If the nozzle becomes clogged with for-

eign materials, such as dirt, excessive

pressure may develop. If the nozzle

becomes partially clogged or restricted,

the pump pressure will pulsate. Clean

the nozzle immediately using the nozzle

kit supplied and the following instruc-

tions:

1. Shut off the pressure washer and

turn off the water supply.

2. Pull trigger on gun handle to relieve

any water pressure.

3. Disconnect the spray wand from

the gun.

4. Remove the high-pressure nozzle

from the spray wand. Remove any

obstructions with the nozzle clean-

ing tool provided and backflush

with clean water.

5. Direct water supply into spray wand

to backflush loosened particles for

30 seconds.

6. Reassemble the nozzle to the

wand.

7. Reconnect spray wand to gun and

turn on water supply.

8. Start pressure washer and place

spray wand into high pressure set-

ting to test.

How to Clean the Water Inlet Filter

This screen filter should be checked

periodically and cleaned if necessary.

1. Remove filter by

grasping end and

removing it from

water inlet of

pump as shown.

2. Clean filter

by flushing it with water on both

sides.

3. Re-insert filter into water inlet of

pump. NOTE: Cone side faces

out.

NOTE: Do not operate pressure washer

without filter properly installed.

STORAGE

Engine

Consult the Engine Owners Manual for

the manufacturer's recommendations

for storage.

Pump

The manufacturer recommends using

a pump protector/winterizer when

storing the unit for more than 30 days

and/or when freezing temperatures

are expected. A pump protector/

winterizer is availabe at the store where

the pressure washer was purchased.

If a pump protector/winterizer is not

available, RV antifreeze needs to be

run through the pump as outlined in the

steps below.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 43 44

Kommentare zu diesen Handbüchern

Keine Kommentare