Black & Decker MULTI-GAS DETECTORS Bedienungsanleitung PDF herunterladen (Seite 47)

BW Defender2

User Manual

Replacing a Sensor or Sensor Filter

a Warning

To avoid personal injury, use only sensors

specifically designed for the detector. See the

section, "Replacement Parts and Accessories."

Each sensor has a high degree of resistance to common

vapors and gases. A sensor will most likely clear itself if you

remove the detector to a clean environment and wait 10 to 30

minutes.

Do not expose a sensor to the vapors of inorganic solvents

(such as, paint fumes) or organic solvents.

The section “If the Detector Does Not Work” describes

problems caused by a sensor in need of calibration or

replacement.

Sensor Filter

The sensors are equipped with a replaceable filter. Check if

the Sensor Screens are dirty. Clean the filters using clean

warm water. Dry before replacing. If they are still clogged

replace the filters

You can also, use a soft brush and warm clean water to clean

the built-in sensor screens on the oxygen and Twin Tox

sensors.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 70 71

Keine Kommentare

Black & Decker MULTI-GAS DETECTORS Bedienungsanleitung Seite 47